Send SETP Dialog
Servername
The MonitorWare Agent 3.0 sends SETP to the server / listener under this name.
Default SETP Port
The Send SETP sends outgoing requests on this port. The default value is 5432.
Please note: The SETP port configured here must match the port configured at the listener side (i.e. MonitorWare Agent 3.0 or WinSyslog Enterprise edition). If they do not match, a Send SETP session cannot be initiated. The rule engine will log this to the NT Event Log.
Options
Under this group box, you can see different options as discussed below:
Enable SSL/TLS
If this option is enabled then this action will be able to connect to SSL/TLS SETP servers. Please make sure that you want this option to be enabled.
Use zLib Compression to compress the data
It enables zLib compression support. Note that the SETP receiver must have zLib Compression support and enabled, otherwise it does not work.
Compression level
Higher level results in better compression but slower performance.
Session Timeout
The maximum time a session to a SETP server is to be kept open.
Advanced Connection Options
In this group box, you can find the options discussed below:
Connection Timeout
Maximum time a connection can take to connect or disconnect.
Send / Receive Timeout
Whern sending or receiving data, this timeout applies.
Please note: If this option is enabled, this action is not be able to connect to NON-SSL SETP servers.